VST Chemical Corp.
P.O. Box 510
Yulan, NY 12792
800-241-7428
RUST EXTERMINATOR (Aerosol)
FEATURES:1. Eliminates Rust
2. Stops Corrosion
3. Paintable
4. No Chlorinated Solvents
DESCRIPTION:Chemically neutralizes rust and leaves a tough, long term, rust preventative coating. Seals, protects and
Prolongs the life of ferrous metal. Rusted area turns to a black protective finish. The protective barrier,
Upon curing can be painted if desired.
. Note: Wearing chemical resistant gloves is recommended.
DIRECTIONS:
1. For best results, work piece and can should be at room temperature (above 65 degrees F).
2. Surface must be clean, dry and free of grease, dirt and oil. Remove loose rust and paint with coarse sandpaper or a wire brush.
3. Before using, shake can until ball rattles freely for at least one minute. Holding the can 8-10 inches from the surface, spray a thin, even coating onto the rusted metal. Avoid over application, sagging and dripping. A second application is advised only after allowing for complete drying of initial application. Final application will dry to a black finish. May be painted after curing for approximately 6 hours.
Packaging:
12 aerosol cans per case
(click here to make this page full screen for bookmarking or printing)
VST Chemical Corp
P.O. Box 510
Yulan, NY 12792
Phone: 1-800-241-7428
Fax: 1-845-557-0596
E-mail:chemicals@ecki.com
All contents Copyright © 1997-2008, VST Chemical Corp. All Rights Reserved. This material may not be reproduced in any form without permission.