VST Chemical Corp.
P.O. Box 510
Yulan, NY 12792
800-241-7428
METAL ARMOR METAL PARTS PROTECTOR
FEATURES:
DESCRIPTION:
A long term, flexible, non-tacky, dust resistant coating that will not crack, peel, flake or chip over a wide temperature range (-40 degrees F to +175 degrees F). Adheres to most clean metal surfaces. Provides a translucent coating which allows identification codes underneath to be read easily. Can be easily removed with mineral spirits or degreasing solvent. Portable aerosol is easy to apply and dispenses a fine uniform film.
Use On: Molds, offshore drilling parts, outdoor airport ground-handling equipment, castings, metal parts in ground or ocean transit, seasonal equipment in storage and any metal part needing to be temporarily sealed against corrosion.
DIRECTIONS:
Make sure surface is clean and dry. Spray a thin uniform film over parts. Allow approximately 5 minutes to set up. For more severe storage conditions, a second coating can be applied within a few minutes. Complete setting of protective coating takes approximately 2 hours. Coating can be removed with mineral spirits or solvent degreaser.
Packaging:
12 aerosol cans per case
(click here to make this page full screen for bookmarking or printing)
VST Chemical Corp
P.O. Box 510
Yulan, NY 12792
Phone: 1-800-241-7428
Fax: 1-845-557-0596
E-mail:chemicals@ecki.com
All contents Copyright © 1997-2008, VST Chemical Corp. All Rights Reserved. This material may not be reproduced in any form without permission.