VST Chemical Corp.
P.O. Box 510
Yulan, NY 12792
800-241-7428
CONCRETE BONDER
FEATURES:
DESCRIPTION:
Concrete Bonder contains an exceptional acrylic polymer formulation that insures strong, permanent bond between new and old concrete, mortar or plaster. It is easy to use…just brush it on any clean, sound surface and apply the new cement mix. Use it inside or outside… This product will increase bonding strength 8 to 10 times when applied as directed. There is no need to chip or roughen the area to be resurfaced or repaired, however, be sure all loose dirt and disintegrated material is removed.
DIRECTIONS:
For thin sectioning use as an "admix" (should not be used as an admix with plaster.) Combine one part product to one part water and add to the dry prepared cement mix...mix thoroughly adding the combined liquids until desired consistency is obtained. Dampen the surface to be repaired and removed any free standing water…apply the cement mix and trowel immediately.
. Surface should be structurally sound. Clean area thoroughly and remove all loose dirt, oil etc.
. Mix as instructed.
. Dampen area to be resurfaced with water. Be sure there are no puddles. Stir this bonder gently and apply with a paintbrush. Cover the area completely to insure proper bonding. Cover no area with this product that can be resurfaced within one hour.
. Apply the prepared cement mix or plaster mix and trowel to a smooth finish.
. One Gallon. covers about 200 square feet. The more porous the surface the less coverage you will receive.
Packaging:
4x1 single Gallons per case
6x1 single gallons per case
5 gallon pails
6 gallon pails
30 gallon drum
55 gallon drum
(click here to make this page full screen for bookmarking or printing)
VST Chemical Corp
P.O. Box 510
Yulan, NY 12792
Phone: 1-800-241-7428
Fax: 1-845-557-0596
E-mail:chemicals@ecki.com
All contents Copyright © 1997-2008, VST Chemical Corp. All Rights Reserved. This material may not be reproduced in any form without permission.