VST Chemical Corp.
P.O. Box 510
Yulan, NY 12792
800-241-7428
SNOW PLOW COATING FOR SNOW PLOWS
FEATURES:
DESCRIPTION:
The latest chemical additives are incorporated in this product to increase the efficiency of snow removal equipment, by plating the blades with hard diamond-like particles. This reduces the friction of the snow and slush against the blade, and reduces the power required to remove a greater volume of snow and ice.
. Because of the corrosion resistant properties of the formulation, it is suggested all snow removal equipment be thoroughly treated at the end of the season. Two light coats, with an hour of drying time between applications, should provide good protection. Under severe conditions of storage (in open area), it may be necessary to re-treat occasionally during the summer months.
DIRECTIONS:
Snow Plows: Apply with hand sprayer, paint roller, or brush. Apply before a snow removal period. If re-applied at the end of each work period, the equipment will be protected from rust and corrosion during a time of inactivity, and be ready to go when next required. A special rust and corrosion inhibitor is a part of the formula. Plow may be used immediately after application buy, if time permits, a drying time of 20-40 minutes is recommended.
Dump Trucks: Spray or brush on load bed of trucks to aid in easy, complete dumping.
Packaging:
minimum order 1 gallon
4x1 single Gallons per case
6x1 single gallons per case
5 gallon pails
6 gallon pails
30 gallon drum
55 gallon drum
(click here to make this page full screen for bookmarking or printing)
VST Chemical Corp
P.O. Box 510
Yulan, NY 12792
Phone: 1-800-241-7428
Fax: 1-845-557-0596
E-mail:chemicals@ecki.com
All contents Copyright © 1997-2008, VST Chemical Corp. All Rights Reserved. This material may not be reproduced in any form without permission.