VST Chemical Corp.
P.O. Box 510
Yulan, NY 12792
800-241-7428

DIESEL FUEL ANTI GEL

FEATURES:

1. Contains less than 5% ppm sulpher and easily passes federal law.
2. Reduces Pour Point
3. .Inhibits Gelling Stabilizes Fuel
4. More Efficiency
5. More Power
6. Less Smoke, Less Moisture and Sludge
7. Cleans Motor & Parts
8. Better Burning & Starting
9. Displaces Moisture Prevents Rust & Corrosion 10. Added lubricant to replace sulpher
   

DESCRIPTION:

This diesel fuel additive complies with the federal low sulpher content requirements for use in diesel motor vehicles (on road) and non-road engines.
This is a concentrated anti-gel product used to keep all types of fuel and diesel oils flowing in cold weather. By interfering with the formation of wax crystals in the fuel, the pour point of the fuel can be reduced by as much as 25 degrees. Fuel flows easily through lines and filters without the need for tank heaters. Eliminates dangerous failures of oil fired boilers, furnaces, and diesel truck and generator engines in cold weather. When used as directed this product will produce more power and efficiency, less smoke, reduce moisture and sludge in fuel. This product cleans varnish from the moving parts of the transfer pumps and injector system, it cleans injectors, fuel pumps and filters. Results in uniform spray pattern, gives even burning and easy starting.

A lubricant is added to replace the sulpher. This lubricant will lubricate parts that it comes in contact with.

DIRECTIONS: (COLD WEATHER TREATMENT)

Add to all grades of fuel at the rate of 1 pint per 150 gallons or 1 gallon per each 1200 gallons of fuel. This dosage will lower the pour point of most residue fuels by approximately 24 degrees. In some cases additional treatment will lower the pour point by several more degrees. For best results the fuel should be a least 10 degrees F. above normal pour point when anti-gel additive is blended in.

DIRECTIONS: (WARM WEATHER TREATMENT)

1. Pour 1 gallon of product for each 1600 gallons of fuel in storage tank.
2. For fuel tanks on equipment add 1 pint for every 200 gallons of fuel.

Packaging:

4x1 single Gallons per case

6x1 single gallons per case

5 gallon pails

6 gallon pails

30 gallon drum

55 gallon drum

(click here to make this page full screen for bookmarking or printing)

Home Page

VST Chemical Corp
P.O. Box 510
Yulan, NY 12792
Phone: 1-800-241-7428
Fax: 1-845-557-0596
E-mail:chemicals@ecki.com

All contents Copyright © 1997-2008, VST Chemical Corp. All Rights Reserved. This material may not be reproduced in any form without permission.