VST Chemical Corp.
P.O. Box 510
Yulan, NY 12792
800-241-7428
GRAFFITI - GO A
FEATURES:
DIRECTIONS:
Spray or sponge onto surface to be cleaned and wipe with clean cloth. If soil is stubborn, repeat application and allow to stand 15-45 seconds. In cases of extreme stubbornness, use bristle brush (fingernail brush) or nylon scrubbing pad, and work into stain. Spray on and wipe again use Clean Cloth.
. Harmless on most surfaces. Care should be exercised when used on synthetic surfaces and soft metals like aluminum. Pre-test in hidden area if uncertain.
. For use on brick motor cinder block and other exterior masonry surfaces.
. Wet affected area thoroughly with water. Spray on product and allow it to penetrate for a few minutes or until mark begins to loosen. Use medium hard nylon brush to dissipate stain or mark. Flush thoroughly with water, or use water hose to wash down masonry.
Packaging:
4x1 single Gallons per case
6x1 single gallons per case
5 gallon pails
6 gallon pails
30 gallon drum
55 gallon drum
(click here to make this page full screen for bookmarking or printing)
VST Chemical Corp
P.O. Box 510
Yulan, NY 12792
Phone: 1-800-241-7428
Fax: 1-845-557-0596
E-mail:chemicals@ecki.com
All contents Copyright © 1997-2008, VST Chemical Corp. All Rights Reserved. This material may not be reproduced in any form without permission.